Buy Rubber Accelerators Rubber Latex Vulcanization & Foam Production

chemical-categories

OCTOCURE DPG-100

OCTOCURE DPG-100 is mainly used as a secondary accelerator or as a booster for thiazoles and sulphenamides. It shows a true synergistic effect with these, giving faster cure rates and higher levels of mechanical properties in all general purpose elastomers. Used as a single acceleraor it is very slow and scorchy. Owing to discoloration it is not recommended to use it in light coloured compounds. It can be used in latex as a secondary gelling agent (foam stabiliser ) in the silico-fluoride foam process.

Properties Suppliers
OCTOCURE MBT-100

OCTOCURE MBT-100 is a medium fast primary accelerator for general purpose rubbers. It is rather scorchy. In NR it gives a broad plateau and thus is not very sensitive to over cure. Vulcanizates accelerated with MBT-powder have very good ageing properties and little tendency to discoloration. By use of secondary accelerators a faster cure can be achieved. For the vulcanization of EPDM rubbers, MBT-powder is a major component of many current vulcanization systems.

Properties Suppliers
OCTOCURE ZDE-100

OCTOCURE ZDE-100 is a primary accelerator of natural and synthetic polymers.

Properties Suppliers
OCTOCURE ZMBT-100

OCTOCURE ZMBT-100 is a primary accelerator for natural and synthetic rubber. It is commonly used as a secondary accelerator in conjunction with a dithiocarbamate.

Properties Suppliers
PILCURE CBS

PILCURE CBS is a delayed action accelerator for sulfur vulcanization. It exhibit faster cure rates at vulcanization temperature but are not activated at processing temperatures. The choice depends on the scorch safety and the properties of the vulcanizates desired.

Properties Suppliers
PILCURE SDBC

PILCURE SDBC is used as water soluble secondary accelerator for NR and SR latex compounds.

Properties Suppliers
PILCURE ZBzDC

PILCURE ZBzDC is a Non-Nitrosamine accelerator for latex and dry rubber based compounds.

Properties Suppliers
PILCURE ZDMC

PILCURE ZDMC is a primary accelerator for latex compounds cured at low temperatures. It is used for dry rubber compounds and also used as secondary accelerators with thiazoles and sulfenamides based cure systems.

Properties Suppliers
Pre-Dispersed Polymer Bound Accelerator CBS-80

Pre-Dispersed Polymer Bound Accelerator CBS-80 is a secondary accelerator of diene rubbers, especially suit for tyres and anti-vibration articles, which can improve the mechanical behavior of products.

Properties Suppliers
Pre-Dispersed Polymer Bound Accelerator DETU-80

Pre-Dispersed Polymer Bound Accelerator DETU-80 causes a very rapid vulcanization of chloroprene rubber, which is necessary of continuous vulcanization. An especially fast acceleration is obtained in the combinations consisting of DETU-80, MBTS-80 and DOTG-80.

Properties Suppliers

1...45678...12