General manufacturers ,suppliers \worldofchemicals.com

General

Extraction Apparatus

Liquid Solid Extraction involves the elution of a solid sample with pure solvent vapour. The sample is held in the extractor body either directly or in a thimble.


Borosil Glass Works Limited

1101, Crescenzo,G-Block, Opposite MCA Club, Bandra Kurla Complex Bandra (East), Mumbai - 400 051. India.

INDIA

+91-22-67406300 / +91-22-24930362

Send Enquiry
Nitric Acid Plant

Nitric Acid Plant uses synthesis by oxidizing ammonia to make nitrogen dioxide, then absorbed over a catalyst and water to form nitric acid. Atmospheric air is filtered and compressed in a centrifugal compressor, which is driven by a hot gas expander and steam turbine. Liquid ammonia is vaporized, superheated and filtered and is joined by the compressed air stream in a double mixing operation based on orificing. The combined ammonia-air mixture enters the converter where the ammonia stream ignites and burns very rapidly to form nitric oxide and water vapor. The hot reaction products and excess air leaving the converter pass through a waste heat boiler and heat exchanger to: cool the process gas before entering the cooler condenser; recover heat be the generation of steam; and recover power by heating the tail gas for use in the hot gas expander. The product acid passes through a bleacher where dissolved oxides of nitrogen are stripped from the acid using a counter current flow of air, before flowing into the storage tank.


Phoenix Equipment Corporation

333 Broad Street, Red Bank, NJ 07701 USA.

UNITED STATES

877-736-9320 /

Send Enquiry
Sulphuric Acid Plant

Sulphuric Acid Plant is used for the manufacturing of sulphuric acid. At present the technologies available for the manufacture of sulfuric acid are the contact process, which is the most widely used technology and the double contact double absorption method. Beside these two another method known as the lead chamber also exist but it is too old to use and not considered a viable option. The contact process is basically the same as the DCDA (Double contact double absorption) but the procedures involved in their application are different. In the contact process sulfur is combusted in the presence of dry air to make sulfur dioxide (SO2). The sulfur dioxide obtained is made to react with the oxygen in the air to form sulfur trioxide. The next step involves concentrating the sulfur trioxide by allowing it to absorb in sulfuric acid, during this process water is added to it continuously in order to sustain the concentration. In the conventional contact process the conversion and absorption is done only once during the whole process whereas in the double contact double absorption process (DCDA) the absorption and conversion is done twice to get better results.


Megatech International Private Limited

G1-1428, RIICO Industrial Area Phase-V, Bhiwadi, Distt.-Alwar, Rajasthan-301019, India.

INDIA

+91-1493-512430 /

Send Enquiry
Graphite Columns

SVICPL offers impervious graphite columns for various applications such as gas scrubbing. Graphite columns are available with various sizes and dimensions to meet customers’ requirements. The impervious graphite columns of SVICPL offer reliable performance due to excellent corrosion resistance to a variety of chemicals.


SVI Carbon Private Limited

Anand Kutir, Plot No. 35, S.No. 110/4+5A-2, Bhd. Shrijay Nagar, Off. Wadala Pathardi Road, Indira Nagar Nashik, Maharashtra - 422 006, India.

INDIA

+(91)-(253)-2326872 / +(91)-9850762935/ 9890040280

Send Enquiry
Pipettes

Pipettes are manufactured from specially selected machine-drawn borosilicate accurate bore glass tubing. They have precision formed jets, bevel ground ends to resist chipping. The graduation marks are in durable white enamel or amber stain, resistant to normal laboratory reagents and repeated washing.


Borosil Glass Works Limited

1101, Crescenzo,G-Block, Opposite MCA Club, Bandra Kurla Complex Bandra (East), Mumbai - 400 051. India.

INDIA

+91-22-67406300 / +91-22-24930362

Send Enquiry
Single Super Phosphate Plant

Single Super Phosphate Plant are known cost-effective operation and increased output. The major raw materials required are rock phosphate and sulphuric acid. The rock phosphate contains tri calcium phosphate which is insoluble in water and hence cannot be taken by the plant. The rock phosphate is reacted with dilute sulphuric acid. The product of reaction is mono calcium phosphate which is soluble in water. This soluble phosphate can be easily consumed by the plants. The measured / weighed quantity of rock phosphates is fed into lead lined & AHR tiles lined mixer, where it is neutralized with dilute sulphuric acid. For making TSP the rock is neutralized with 54% phosphoric acid. The reaction is very fast in the beginning and the material is fine slurry which thickens quickly. The material is discharged in the den where the material slowly solidifies. The den discharge is fitted with den cutter which cuts the solid cake to powder. The fluorine based gases are liberated which are sucked by ID fan and scrubbed in multi stage conventional scrubbers & venturi scrubbers. The material get cured in a few days time.


Gayatri Fertiplants International Pvt Ltd

158, Bhagwat Bhawan, Sabji Mandi, Maujpur New Delhi - 110053, India.

INDIA

+91 9772964748 /

Send Enquiry
Edlon Coatings

Edlon Coatings has been engineered for resistance to chemical and mechanical damage in corrosive environments and high purity applications.They are used on virtually any metallic surface capable of withstanding processing temperatures (700-800F). Coatings are field-repairable and can be applied to complex shapes through both manway and open access to both tanks and columns, which makes fluoropolymer coatings an excellent option for coating.


Robbins & Myers Process Solutions Group

51 Plum Street, Suite 260 Dayton, OH 45440 USA.

UNITED STATES

937.458.6600 /

Send Enquiry
Sulphuric Acid Concentration Plant

Sulphuric Acid Concentration Plant is mostly performed under vacuum in order to reduce the operating temperature, especially for high concentrations. The plant comprises of equipments wherein the wetted parts are made up of Borosilicate glass 3.3, Fluoropolymers (PTFE, PFA, FEP, PVDF, PP, etc), High Nickel alloys, Graphite & exotic metals (Ta, Ti, Nb, etc.). The plants can be totally automated by PLC or DCS based systems and even integrated with computers.


K-Jhil Scientific Glass

Vishakha Sadan, No-2, B-101, CSC Road, Dahisar-East, Mumbai–400 068, Maharashtra, India.

INDIA

+91-22-28764153 /

Send Enquiry
CRANE SCALES

Contech manufactures Crane Scales for weighing upto 50 ton. Options available are remote key panel, heat shielding for high temperature application in foundries, Metallurgy and wireless remote Indicator.


Contech Instruments Ltd.

301 Punit Industrial Premises, Turbhe, Navi Mumbai, India..

INDIA

00 91 22 27611176 / 00 91 22 27611180

Send Enquiry
Sulphuric Acid Plant

Sulphuric Acid Plant is designed to formulate sulphuric acid which is used to make detergents, chemicals, ferric and non-ferric alums. This plant is manufactured by its dexterous professionals using the finest quality components and cutting-edge techniques. The key features are it is easy to operate, it has hassle-free operation, it is energy efficient and further it has longer service life.


Kapoor Engineering Works

Railway Station Road, Saharanpur, Uttar Pradesh, India..

INDIA

+91-7351330002 / +91-132-2612688 /

Send Enquiry
1...34567...30

Looking to Buy Chemical Equipment? Place Your Request Now!

www.worldofchemicals.com uses cookies to ensure that we give you the best experience on our website. By using this site, you agree to our Privacy Policy and our Terms of Use. X