Rice University researchers used mixture diamond nanoparticles, mineral oil testing heat transfer applications

Mixture of diamond nanoparticles, mineral oil for heat-transfer applications

6:54 AM, 1st April 2014
Rice University research on heat transfer applications
An electron microscope image shows diamond nanoparticles suspended in oil. The inset shows the diffraction planes of the particles.

HOUSTON, US: According to a new research by Rice University, a mixture of diamond nanoparticles and mineral oil easily outperforms other types of fluid created for heat-transfer applications. Rice scientists mixed very low concentrations of diamond particles (about 6 nanometre in diametre) with mineral oil to test the nanofluid’s thermal conductivity and how temperature would affect its viscosity. They found it to be much better than nanofluids that contain higher amounts of oxide, nitride or carbide ceramics, metals, semiconductors, carbon nanotubes and other composite materials.

Thermal fluids are used to alleviate wear on components and tools and for machining operations like stamping and drilling, medical therapy and diagnosis, biopharmaceuticals, air conditioning, fuel cells, power transmission systems, solar cells, micro- and nanoelectronic mechanical systems and cooling systems for everything from engines to nuclear reactors.

Fluids for each application have to balance an ability to flow with thermal transport properties. Thin fluids like water and ethylene glycol flow easily but don’t conduct heat well, while traditional heat-transfer fluids can be affected by stability, viscosity, surface charge, layering, agglomeration and other factors that limit essential flow.

Researchers have been looking since the late 1990s for efficient, customizable nanofluids that offer a middle ground. They use sub-100 nanometer particles in low-enough concentrations that they don’t limit flow but still make efficient use of their heat-transfer and storage properties.

Nanodiamonds are proving to be the best additive yet. They carry most of the properties that make bulk diamond so outstanding for heat-transfer applications at the macro scale. Single diamond crystals can be 100 times better at thermal conductivity than copper while still acting as an efficient lubricant.

“The great properties of nanodiamond - lubricity, high thermal conductivity and electrical resistivity and stability, among others - are quite impressive. We found we could combine very small amounts with conventional fluids and get extraordinary thermal transport without significant problems in viscosity,” said Jaime Taha-Tijerina, Research Scientist, Rice University.

In tests, the researchers dispersed nanodiamonds in mineral oil and found that a very small concentration - one-tenth of a percent by weight – raised the thermal conductivity of the oil by 70 per cent at 373 kelvins (about 211 degrees Fahrenheit). The same concentration of nanodiamond at a lower temperature still raised the conductivity, but to lesser effect (about 40 percent at 323 K).

They suggested a mechanism somewhat like percolation – but perhaps unlike anything else yet seen — takes hold as oil and diamond molecules collide when heated.

The work that could improve applications where control of heat is paramount was led by Pulickel Ajayan, chair of Rice’s new Materials Science and NanoEngineering Department, and Rice alumnus Jaime Taha-Tijerina, now a research scientist at Viakable Technology and Research Center in Monterrey, Mexico, and a research collaborator at Carbon Sponge Solutions in Houston.

“Brownian motion and nanoparticle/fluid interactions play an important role. We observed enhancement in thermal conductivity with incremental changes in temperature and the amount of nanodiamonds used. The temperature-dependent variations told us the changes were due not just to the percolation mechanism but also to Brownian motion,” said Taha-Tijerina.

© Rice University News

0 Comments

Login

Your Comments (Up to 2000 characters)
Please respect our community and the integrity of its participants. WOC reserves the right to moderate and approve your comment.

Related News


Concern over electronic cigarettes on the rise

WASHINGTON DC, US: With sales of electronic cigarettes (e-cigarettes), on the rise and expected to hit $1.5 billion this year, concerns over potential ...

Read more
New terahertz technology to detect explosives at airports

WASHINGTON DC, US: Researchers have reported a precise and direct method for using that “terahertz” (THz) technology to detect explosives ...

Read more
Chevron Phillips to expand sulfur chemicals facility in Belgium

THE WOODLANDS, US: Chevron Phillips Chemicals International NV, a wholly-owned affiliate of Chevron Phillips Chemical Company LLC, is expanding its Te ...

Read more
KBR bags EPCL’s condensate refinery upgrading contract in Jebel Ali

HOUSTON, US: KBR has been awarded a front-end engineering design (FEED) contract by Emirates National Oil Company Processing Company LLC (EPCL) for th ...

Read more
Asahi Kasei opens acetonitrile plant in Ulsan, Korea

ULSAN, KOREA/ TOKYO, JAPAN: Asahi Kasei Chemicals held an opening ceremony for a new acetonitrile plant on 27 March 2014. The company had completed th ...

Read more
BASF to expand superabsorbent polymers production

LUDWIGSHAFEN, GERMANY: BASF is going to expand its leading position in the production of superabsorbent polymers for the global hygiene industry with ...

Read more