chemical process equipment Suppliers in UNITED STATES

Fluid Bed Dryer is manufactured using 304 Stainless Steel. It has 48" Wide x approximate 135" long 2 zone bed. It has approximate 72" long wedge wire section with (2) screen sections, 3 total separations. It is provided with top clamp down cover with lifting mechanism, top end feed, bottom end discharge. It is driven by a M5H vibrating motor, 1.5hp, 3/60/230/460 volt, 1725 rpm. It includes a water coil and further the equipment is mounted on a carbon steel frame.

Stainless Steel Pressure Vessel has approximately 24" diameter X 24" straight side. The internal rated is 15 PSI /FV @ 360 degrees F. The jacket rated is 15 PSI @ 360 degrees F. It has shell thickness 140. and further has 1" center bottom outlet.

Cooling Tower has certified capacity 2,515 GPM from 95 degrees F to 85 degrees F @ 78 degrees wet bulb. It is equipped with one-piece multi groove, neoprene/polyester powerband belt drive system with aluminum fan sheave. It has electric immersion heater packages with (2) 12KW 480/3/60 elements, thermostat, contractor, and low water cut out protection. It is provided with air intake screens. Fan motor is 60HP, TEAO, 460-3-60 (2 speed/2 winding). Overall dimensions is 18'-10 3/8" tall X 21'-6 1/2" long X 12' wide.

MS-32 Media Mill is used for ultra fine grinding of slurries of various viscosities. It is provided with mechanical seal, "min-max" pressure and temperature gauges, with internal working pressure of 2.5 bar (maximum). The unit Includes hydraulic bowl lifting device. The main drive is provided with 30HP Reliance motor with US Ex-Proof machine mounted cabinet (460V-3PH-60HZ). The unit includes "Steimel" product feed pump (gear pump w/ mechanically variable speed control), model T1-60P, with 1/2 HP US ex-proof reliance motor.

Centrifugal Blower is a Four-Bearing Outboard (4BOB) blower provided with multistage centrifugal unit which handles air and other gases, working either as blower or exhauster. It is provided with 100 HP, 230/460V3500 RPM, TEFC Motor. Rated 1633 CFM, Diff. Pressure Oz: 134, Inlet pressure PSIA: 11.89, 100 deg F.

Reactor is rated for 100 psi & FV @ 480 Deg. F. internal; rated for 90 psi @ 480 Deg F. jacket. The dimensions is 30" I.D. x 18" T/T. Complete with 2.5 DTW variable speed drive, it is provided with mechanical seal with lubricator. The agitator speed is 50-175 RPM.

Drum Flaker has 5' diameter x 7' and is chrome plated. It has 10 HP ex-proof varidrive w/ 3 to 1 speed variation. The speed is 125 RPM Max. Further it is available with unused spare drum. It is widely used in chemical process industries.